Table 5 – Brocade TurboIron 24X Series Hardware Installation Guide User Manual
Page 40
30
Brocade TurboIron 24X Series Hardware Installation Guide
53-1002981-01
Testing connectivity
3
If a problem persists after taking these actions, contact TurboIron technical support.
TABLE 5
Network connection-related LED states
LED
Desired State
Meaning
Abnormal
State
Meaning or Action
Link
(Lnk)
On (Green)
A link is established
with the remote port.
Off
A link is not established with the remote port.
You can do the following:
•
Verify that the connection to the other
network device has been properly made.
Also, make certain that the other
network device is powered on and
operating correctly.
•
Verify that the transmit port on the
Brocade device is connected to the
receive port on the other network device,
and that the receive port on the Brocade
device is connected to the transmit port
on the other network device. If you are
uncertain, remove the two cable
connectors from the port connector and
reinsert them in the port connector,
reversing their order.
•
Dust may have accumulated in the cable
connector or port connector. For
information about cleaning the
connectors, refer to
•
If the other actions don't resolve the
problem, try using a different port or a
different cable.
Active
(Act)
On or blinking
(Yellow)
The port is
transmitting and
receiving user
packets.
Off for an
extended
period.
The port is not transmitting or receiving user
packets. You can do the following:
•
Check the Link LED to make sure the link
is still established with the remote port.
If not, take the actions described in the
Meaning or Action column for the Link
LED.
•
Verify that the port has not been
disabled through a configuration
change. You can use the CLI. If you have
configured an IP address on the device,
you also can use Brocade Network
Advisor.