Accusys eXpeRAID - Manual (Page 17)

ACCUSYS, INC.
5F, 38 TAIYUAN ST, JHUBEI, HSINCHU, TAIWAN, R.O.C.
TITLE EXPERAID COMMAND LINE INTERFACE USER GUIDE
PROJECT “DESKTOP RAID” DOCUMENT STATUS OFFICIAL RELEASE
REV. G–05-NOV-2007 PAGE 17 OF 27
3.3.3.2
Command Name Command Description
DeleteArray Use this command to delete a specified array.
Parameter 1 Parameter Description
Array No.:
Specify an array number to be deleted.
Example
Array No.:
<1~4>
CLI>DeleteArray 1 [Enter]
Array 1 will be deleted if it exists and is not in use.
3.3.3.3
Command Name Command Description
CreateJBOD Use this command to create JBOD with the specified drive number.
Parameter 1 Parameter Description
Drive No.:
<1~n> Drive No.:
<1~n>, where n stands for maximum available drive number.
3.3.3.4
Command Name Command Description
DeleteJBOD Use this command to delete an existing JBOD.
Parameter 1 Parameter Description
JBOD No.:
<1~n> JBOD No.:
<1~n>, where n stands for maximum JBOD number.
3.3.3.5
Command Name Command Description
SetSlice Use this command to set a slice for the specified array.
Parameter 1 Parameter Description
Array No.:
<Array=<1~4>>
Parameter 2
Slice Number:
<Slice=<0~15>>
Parameter 3 Array No.:
Specify an array number to set slice.
Slice Number:
Specify the slice number to be created.
Slice size:
Measures in GBytes. Set “Size=0” to delete a slice.
Example
Slice size:
<Size=xxx>>
CLI>SetSlice Array=1 Slice=0 Size=120 [Enter]
Slice 0 will be set to 120GB if Array 1 exists and the free capacity of
Array 1 is large enough(>120GB).