Accusys eXpeRAID - Manual (Page 8)

ACCUSYS, INC.
5F, 38 TAIYUAN ST, JHUBEI, HSINCHU, TAIWAN, R.O.C.
TITLE EXPERAID COMMAND LINE INTERFACE USER GUIDE
PROJECT “DESKTOP RAID” DOCUMENT STATUS OFFICIAL RELEASE
REV. G–05-NOV-2007 PAGE 8 OF 27
3. Type: mknod /dev/ACS_CDEV0 c 253 0 [Enter], a device file “ACS_CDEV0” will be
created and CLI will be able to find the controller through this device file.
2.2 Execution Mode
There are two methods to run CLI commands - interactive mode and non-interactive mode.
For each mode, all commands and parameters must follow the CLI command format to be
executed normally.
2.2.1 Interactive Mode
To trigger CLI interactive mode, simply run the CLI execution file under the
command line of the OS. If the controller has been found, a password verification
prompt for the default controller will appear. After inputting the correct password,
the CLI prompt “CLI>” will appear. All CLI commands can be executed under this
prompt.
2.2.2 Non-interactive Mode
There are two types of non-interactive mode for CLI. One calls the CLI command
"RunScript" to execute pre-written script files which contain bunches of CLI
commands. The other one calls CLI commands by adding them as the parameter
of the CLI execution file individually.
The scripts of both types of non-interactive mode are written based on the following
format:
acs_cli <CLI command> [Parameters of the CLI command]
which can be executed as a single command under the command line of the OS.
2.2.2.1 CLI script Mode