Lincoln Electric IM753 RANGER 9 - Manual (Page 27)

D-3 MAINTENANCE D-3
BATTERY CHARGING
ONAN P220OHV KOHLER CH20S
ONAN 122-0737 KOHLER 1205001
Oil Filter FRAM PH4967 FRAM PH3614*
Air Filter ONAN 187-6068 KOHLER 4708303
Element FRAM CA79
Air Filter N / A KOHLER 2408302
Pre-Cleaner
Fuel Filter ONAN187-6119 KOHLER 2505002
FRAM G1
Spark Plugs ONAN 167-1638 CHAMPION RC12YC
(Resistor NGK BPR4EY (.030” GAP)
Type) (.025” GAP)
* Oil capacity increases from 2.0 Qts. to 2.1 Qts. when using this filter.
Engine Maintenance Parts
GASES FROM BATTERY can explode.
• Keep sparks, flame and cigarettes away
from battery.
To prevent EXPLOSION when:
• INSTALLING A NEW BATTERY - discon-
nect negative cable from old battery first
and connect to new battery last.
• CONNECTING A BATTERY CHARGER
Remove battery from welder by discon-
necting negative cable first, then positive
cable and battery clamp. When reistalling,
connect negative cable last. Keep well
ventilated.
• USING A BOOSTER - connect positive lead
to battery first then connect negative lead
to engine foot.
• BATTERY ACID CAN BURN EYES and SKIN
Wear gloves and eye protection and be
careful when working near battery.
Follow instructions printed on battery.
------------------------------------------------------------------------
WARNING
BATTERY
• When replacing, jumping, or otherwise connecting
the battery to the battery cables, the proper polarity
must be observed. Failure to observe the proper
polarity could result in damage to the charging
circuit.
The positive (+) battery cable has a red terminal
cover.
• If the battery requires charging from an external
charger, disconnect the negative battery cable first
and then the positive battery cable before attaching
the charger leads. Failure to do so can result in
damage to the internal charger components. When
reconnecting the cables, connect the positive cable
first and the negative cable last.
HARDWARE
Both English and Metric fasteners are used in this
welder.
RANGER 9