LT Security LTD2316ME - Manual (Page 40)

DVR User Manual
34
4.5.4 Other alarm
This tab gives a choice to configure alarm for Disk Full, IP Conflict, the
Disconnect event, Disk Attenuation or Disk Lost.
Step1: enter into system configurationother alarm; refer to Fig 4-27:
Step 2: Use the dropdown menu and select the event or the alarm.
Step 3: Check the required trigger options.
If the selected event is
“Disk Full”, then use the drop down box for “Disk
Shortage Alarm ” to choose a threshold value for remaining HDD space. If the
threshold value is reached, the system will trigger the Disk Full Alarm.
Click
“Apply” to save settings; Click “Exit” to exit the current interface
Fig4-27 other alarm
4.5.5 Alarm out
Alarm out includes three sub menus: alarm out, schedule and buzzer
① Alarm out
Step 1: enter into system configurationalarm out; refer to Fig 4-28:
Step 2: in this interface, user can set relay alarm out name and select hold time
which means the interval time between the two adjacent alarms.
Step 3: user can setup all channels with same parameters.
② Schedule
Step 1: enter into system configurationschedule;
Step 2: the setup steps of alarm out schedule are familiar with schedule; user can
refer to 4.4.1 Schedule for details.
Note: the default schedule of motion detection is full-selected, that is, Fig 4-28 system configuration-alarm out
the color of schedule setting interface is blue.
③ Buzzer
Step1: enter into system configurationbuzzer;
Step2: tick off Buzzer and set buzzer alarm hold time