LumaSense Technologies INNOVA 1316A-1 - Manual (Page 62)

Chapter 4
_________________________________________________________________________________________
_____________________________________________________________________________
BE6020-14 1316A-1 Multi Gas Monitor LumaSense Technologies A/S
Instruction Manual Page 62 of 98
Figure 4.6. Status Window displaying Operation Mode “Start up”.
2. The Multi Gas Monitor – INNOVA is in Stand By mode.
3. A Flow Fault has been detected, see figure 4.4 ,”Pump Out
Flow” caused by exceeded pressure limits.
4. If the CO
2
, CO, or HC channel gain cannot be set (e.g., the IR
signal is too strong), the following warnings occur, see figure
4.7 .
CO
2
Zero Fail.
CO Zero Fail.
HC Zero Fail