Mediabridge MWN-WAPR300N User Guide - Manual (Page 28)

MWN-WAPR300N
23
 Enable Bandwidth Control: enables or disables the internal IP bandwidth
control. The default is disabled.
 IP Range: The IP address range of the hosts whose traffic has been controlled. It
can be a single IP address or IP address range. (For Single IP, enter the same IP
in both fields.
 Upload/Download: specifies the traffic direction for the selected IP addresses.
 Bandwidth Range: The maximum and minimum upload/download data traffic of
the hosts in specified IP range. The unit is KByte/sec. The uplink of upload and
download cannot exceed the WAN port bandwidth limitation range (by default is
1500 or 1492).
 Enable: enables the current edited rule. Otherwise, the rule will not go into
effect.
 Add to list: After you edit the rule, click the “Add to list” button to add the current
rule to the rule list.
Here we take 2Mbps bandwidth as an example. Theoretically, the biggest downloading
rate for 2Mbps bandwidth is 2Mbps=256KByte/s, and the biggest uploading rate is
512kbps=64KByte/s
Example 1
If you want to set the download rate of the computer at the IP address of 192.168.8.2 as
80-90KByte/s, upload rate as 10-15KByte/s, first add one upload rule as shown in the
picture below: