Mediabridge MWN-WAPR300N User Guide - Manual (Page 55)

MWN-WAPR300N
50
 Enable: Check to enable remote web management.
 Port: The management port open to outside access. The default value is 8080.
 IP Address: Specify the range of the Public IP addresses of the computers on the
Internet for remote management.
NOTE:
1. If you want to log into your Medialink router’s Web-based Utility via port 8080, you
need to use the format of WAN IP address: port (for example http
：
//220.135.211.56:8080) to implement remote login.
2. If your WAN IP address starts and ends with 0.0.0.0, it means all hosts on the Internet
can implement remote Web management. If you change the Internet IP address to be a
range like this: 124.88.97.17-124.88.97.19, then only the computers at the IP addresses
of 124.88.97.17, 124.88.97.18 and 124.88.97.19 can access the Router to implement
remote web management.
For example:
If you want to configure the computer at the IP address of 124.88.97.17 to access the
router’s web-based utility via port 8080, please set the parameters as above.
Chapter 9 Routing Settings
9.1 Routing Table
This page shows the router’s core routing table.