Mediabridge MWN-WAPR300N User Guide - Manual (Page 39)

MWN-WAPR300N
34
Channel: <MUST Match First MWN-WAPR300N>
Extension Channel: <MUST Match First MWN-WAPR300N>
Wireless Security: <MUST Match First MWN-WAPR300N>
Wireless Working Mode: WDS Bridge Mode
DHCP Server: Enabled (will be disabled as the last step of this configuration)
Connect the Second MWN-WAPR300N to the First MWN-WAPR300N wirelessly:
1. C
lick “Open Scan” and select the First MWN-WAPR300N from the list and click
the
”OK” button on the dialog box and then the corresponding wireless MAC address will
be added to the AP MAC address field automatically.
2.
Scroll down to the bottom of the page and click “Apply” after the MAC address is
added.
Connect the First MWN-WAPR300N to Second MWN-WAPR300N wirelessly:
Repeat the steps above on the First MWN-WAPR300N to pair the two routers.
Disable DHCP on the Second MWN-WAPR300N: Login to the Second
MWN-WAPR300N at http://192.168.8.2
and disable the DHCP Server. Click “Apply”.
Power Cycle: After you are finished, power down both devices. Then power up the First
MWN-WAPR300N first and then power up the Second MWN-WAPR300N. You will now
have a stronger signal to which you can connect.
Placement: You may now unplug the power from the Second MWN-WAPR300N and
move it wherever you have an open electrical outlet. Ideally, the Medialink router should