Mediabridge MWN-WAPR300N User Guide - Manual (Page 35)

MWN-WAPR300N
30
Security: Enter the Key (password for your existing wireless network). If you do not
know the key (password)
of your existing router, consult your existing router’s User
Manual.
Apply: Scroll down and c
lick “Apply” to finalize the settings.
Power Cycle: After you are finished, power down both devices. Then power up the first
router (your existing wireless router) first and then power up the Medialink router second.
You will now have a stronger signal to which you can connect.
Placement: You may now unplug the power from the Medialink router and move it
wherever you have an open electrical outlet. Ideally, the Medialink router should be
placed halfway between your existing router and the ultimate location you wish to have a
stronger signal. The key to placement is that wherever you choose to place this
Medialink router should be a place in which you can successfully connect to your primary
wireless network.
Connectivity: You should now be able to access the internet by connecting a device to
either router via Ethernet or wirelessly. If you cannot access the internet through the
Medialink 300N router, make sure it is not too far from the primary router and make sure
the security settings match on both routers.
Please note that when using this router as a Range Extender, devices that connect to
your new Medialink 300N router will be able to access all devices within your network.
However, devices that are connected to your primary router will not have access to the
devices connected to the Medialink 300N router. For example: