Spectra Precision ProMark Field Software - Manual (Page 14)

English
8
• [16]: Takes you to the Microsoft Home screen by
minimizing the ProMark Field window. Tap on the ProMark
Field icon (
) at the bottom of the screen to return to
ProMark Field.
Dragging the Map
on the Screen
Use one of the following two methods.
• Press the ESC key to move the arrow symbol representing
your current position back to the center of the map screen.
Following this action, the whole screen is updated to
reflect the map shift.
• Drag the stylus in the desired direction.
A routine is also implemented bringing your current position
back to the center of the screen after 15 seconds of idle time
on the map screen.
Setting General
Parameters
1. Tap Menu>Options.....This opens the Survey tab on which
you should choose the type of survey you wish to perform.
These settings only make sense if you are using your
receiver as a rover. Ignore them if the receiver is used as
a base.
• Type: Choose whether you will be using your rover in
static, stop & go kinematic or continuous kinematic
mode, Note that a rover cannot be used in static if
intended to be used in a real-time application.
• Mode: Choose whether you will be performing a real-
time or post-processed job with your rover. The choice
you make here impacts the available initialization
modes. If you select “Real-time”, four initialization
modes will be available whereas only two will be
possible if “Post-processing” is selected (see
Initialization on page 48).
These settings are not part of the job itself, which means
they won’t be restored automatically next time you re-open
the job.
Please keep this setting unchanged until you open a new
job. At that time, you may decide to keep or change this
setting depending on the nature of the new job.
NOTE: Only the real-time mode can be used if an shp job
is open.