Spectra Precision ProMark Field Software - Manual (Page 38)

English
32
Using Your Rover in a Real-Time RTK Project
Choosing the
Survey Type and
Mode
Read the table below to choose the survey type and mode
suitable for your project.
Use the Survey tab on
ProMark Field’s Options
menu for this setting.
There is only one system setup possible for a rover used in a
real-time RTK project, which is to mount it on a pole or bipod:
• Place the receiver in its field bracket and mount the
assembly onto the pole at a suitable height.
• Secure the antenna provided at the top of the pole.
• Connect the antenna to the receiver antenna input using
the coaxial cable provided.
• Determine the length of the pole. The real height of the
antenna will be deduced from this value
Setting an RTK
Rover
Device used to receive corrections:
• If you are using a cellular modem, make sure you have
purchased and inserted the SIM card that will allow the
modem to fulfill this task.
Your Project Setup Survey
Logging Points:
You want to collect centi-
meter-accurate positions
in real time on each of the
surveyed points.
Receiver and antenna
mounted on a pole or bipod:
Real-time, Stop &
Go Kinematic
Logging Points along a
Line:
You want to collect centi-
meter-accurate positions
in real time, at regular
intervals of time or dis-
tance, along a line.
Real-time, Continu-
ous Kinematic
Staking out Points:
You want to be guided suc-
cessively to each of the
points listed in your job so
you can place a stake on
each of them (or simply go
back to each of them).
Real-time, Stop &
Go Kinematic