Spectra Precision Survey Pro v4.6 Ranger User Manual - Manual (Page 32)

User’s Manual
22
HR field showing the HR entered plus the offset. (The raw data file
will also clearly note when a rod height offset is being applied.)
The Prism Constant field should contain the prism constant for the
prism associated with this Smart Target as long as a prism constant
is not also set in the total station. If a prism constant is set in Survey
Pro and on the total station, it will be applied twice resulting in
incorrect distance measurements for every shot.
If you are using a robotic total station that supports prisms that
output a target ID, the Use Target ID field will be available where you
can specify the target ID for the Smart Target.
If Use For Search is available and selected, the total station will only
look for the Target ID when it is searching for the target. Once the
target is found, it will track the prism, but it is possible for the total
station to start tracking a different reflector that comes into view. If
Use Always is selected, the total station will continuously monitor the
Target ID and only track the prism with the specified Target ID.
Tap to close the Edit Smart Targets screen and save any changes.
Map View
from the command bar, or from various screens
Many screens provide access to a map view. The map view is a
graphical representation of the objects in the current job.
Map View without basemaps Map View with basemaps