Spectra Precision Survey Pro v4.6 Ranger User Manual - Manual (Page 325)

Basic GPS Module
315
Hanging Up and Redialing a Cellular
Phone
To hang up an active connection, tap Survey >
GPS Status > Cell Modem > Hang up from the
Main Menu.
If a connection was made previously, the Dial
will be available. Tapping it will attempt to
reconnect to the last connection that was made,
including selecting the same NTRIP service, if
applicable.
Solve Projection
The solve projection routine will appear any time the coordinate
system is not solved. The requirements for solving a projection are
described in the Coordinate System Set or Solved section on Page 223.
Projection Control Points Status Screen
The Collect Control Points screen appears in one of two states: GPS
Backsight or GPS Resection.
• GPS Backsight: This state exists only in Ground TDS
Localization mode and when the base is set on an existing job
point with accurate NEE coordinates. One additional control
point is needed to orient the setup.
• GPS Resection: This state exists when the base was set on
a new point. A new point is a point that was created from an
autonomous setup.