AW Gear Meters RT-15 - Manual (Page 11)

RT‐15 Flow Monitor
Operation and Programming Manual
10
Dimensions
Wiring Connections
Make wiring connections to terminal strips inside the rear cover. Unit has a ¾‐inch NPT wire exit for
conduit connection. Connection to conduit maintains the enclosure’s hazardous‐location rating. The
connection must meet all local and national electrical codes.
To prevent ignition of hazardous atmospheres, disconnect circuits before removing cover. Keep cover
tightly closed while circuits are alive.
DC Power Connection
The RT‐15 requires a 15‐24 VDC/200mA supply for operation.
A power supply is still required to operate the RT‐15 even if the analog output is used in a loop‐powered
configuration.
Warning!
Notice