Run mode screens, L1 l2, Rt-30ex flow transmitter – AW Gear Meters RT-30EX User Manual

Page 13: Rate

Advertising
background image

RT-30EX Flow Transmitter

Operation and Programming Manual

13

RT-30EX User Manual, Rev. 1.7 02/07/2012

RT-30

S/N 0000000

Software Version 1.1.3

HART SW version 1.1.0

RATE

100.00

GPM

LN GT

TOTAL

249.00

GAL

GRAND TOTAL
12345.67

GAL

RT 12345.67

GPM

TO 12345.67

GAL

LN GT

STATUS

L1 OFF : L2 OFF

RA 2345.67 HZ
TO 1234567 PUL
ANLG 20.00mA

ANALOG OUT

XX

20.00 mA

LN GT

UP/DN

UP/DN

UP/DN

UP/DN

UP/DN

UP/DN

UP/DN

DN

Rate
ON/OFF
Total

ON/OFF

L1
L2

UP

Run Mode Screens

The run mode screens, as shown below, can be accessed by using the

UP

and

DN

buttons or using the

attached magnet wand to activate internal hall switches.

Logo screen shows critical information on RT-30EX firmware version

RATE screen shows active flow rate information in programmed
engineering units

TOTAL screen shows totalized volume in programmed engineering
units


RT/TO screen shows both the flow rate and total values in
programmed engineering units


GRAND TOTAL screen shows totalized volume in programmed
engineering units and is not affected if TOTAL is reset.

STATUS screen shows data summary. Flow and total are in un-scaled
units of Hertz for flow and Pulses for total.



ANALOG OUT screen shows the mA value the RT-30EX is outputting.


L1/L2 screen shows information for Limit outputs.


Figure 9: Run Mode screens - overview

Advertising