AW Gear Meters RT-30EX - Manual (Page 8)

RT-30EX Flow Transmitter
Operation and Programming Manual
8
RT-30EX User Manual, Rev. 1.7 02/07/2012
Connections
On dual access enclosure versions, the hook-up board can be accessed by removing the blind cover.
To get access to the hook-up board on the single access enclosure models, first remove the cover and
loosen the 4 stainless steel screws visible through the face plate as shown in Figure 18. Note that the
screws are captured on the back side of the main display board and will not fall out. Carefully remove
the main display board. The hook-up board is located at the bottom of the enclosure as shown in Figure
2 below.
Figure 2: Single access enclosure model, hook-up board location
To get access to the sensor wiring terminal which is located on the back of the main display board, the
same procedure must be followed for both the single and dual access enclosure models.