AW Gear Meters LLC-E-BA - Manual (Page 13)

AW-Lake Company 8809 Industrial Drive, Franksville, WI 53126  web: www.aw-lake.com
 Tel: 262-884-9800  Fax: 262-884-9810  Email: [email protected]
REV. 1.3 LLC-E-BA Manual rev 3.3.10.DOC
13
PROGRAM Mode
The Program Mode is used to enter, edit, or examine the programmed variables and batch quantities.
Program variables must be entered before the batch programming. The RUN/PROGRAM key-
switch must be in the vertical PROG position to enter the PROGRAM mode.
Default Variables
The LLC-BA has been programmed by AW Company with either the default variable values listed in
Table 1 or with values determined specifically for the supplied flow transmitter and the requested
engineering units. If the variable values are the defaults shown here, follow the directions in the next
sections to determine and enter the variable values for your application. Record your entries in this
manual in the space provided in Table 1. If the variable values found in the LLC-P are not the
default values shown below, these programmed values will in most cases be the optimum values
and no editing will be required.
Batch numbers 1 through 9 will contain the default values shown in Table 1 and will require editing
for your specific application. Record your entries in this manual in the space provided in Table 1.
Variable Name Default Value Programmed Value
DELAY 00000.50
PRECUT 0000000.
0-SET mA.s 0000x.xx
GTIME[s] 0000001
KFR 00100.00
DP KFR 00000.00
E-UNITS KFT hz
KFT 0010000.
DP KFT 0000000.
E-UNITS KFT pul
Batch Number Default Value Programmed Value
BATCH #1 100.00
BATCH #2 000.00
BATCH #3 000.00
BATCH #4 000.00
BATCH #5 500.00
BATCH #6 000.00
BATCH #7 000.00
BATCH #8 000.00
BATCH #9 900.00
Table 1