AW Gear Meters LLC-E-BA - Manual (Page 8)

AW-Lake Company 8809 Industrial Drive, Franksville, WI 53126  web: www.aw-lake.com
 Tel: 262-884-9800  Fax: 262-884-9810  Email: [email protected]
REV. 1.3 LLC-E-BA Manual rev 3.3.10.DOC
8
Initial Display Messages
The LLC displays some initial messages at power up. After 5 seconds the LLC will briefly display
***AW Company*** and then the following four variables for approximately 2 seconds each. After
these brief displays, the LLC will display RATE or the last selected Mode.
VERSION a w 1 . XX - Indicates the software version installed in the LLC.
ON COUNT -> 00000XX -
ΑON≅ count indicator increments each power-on cycle of the LLC.
LEFT MEM%0000100 - Memory life indicator displays % of memory life remaining in 10%
increments. The LLC stores programmed variables and retained totalizer values in EEPROM
(electrically erasable memory), not a battery. Limits to the number of times memory can be re-written
results in a minimum EEPROM life of 5 years with continuous use. This socket mounted memory IC
is field replaceable and replacement memory ICs are available. Care must be used to insert the new
memory IC in the exact same orientation as the one removed. Program variables require
reprogramming after memory IC change.
BLK LOC 0000XXX - Block Location, Used by LLC for EEPROM memory management.
Display Mode Selection
Display modes are selected differently in the PROGRAM Mode than in the RUN Mode.
While in the PROGRAM Mode, pressing the [MODE]-key (
UP ) changes the display mode from one
to the next. The [MODE]-key ( UP ) also selects which Totalizer may be reset while in the
Programming Mode.
When in RUN Mode, the Display Mode is selected by use of the momentary MODE toggle switch on
the front of the enclosure in the upper left hand corner. The modes are indicated on the LLC-E-BA
front label directly under the MODE switch in the order that they will appear. Pushing the MODE
switch down and releasing it quickly will change the display from one mode to the next. Holding the
MODE switch down causes the display to slowly scroll through the modes. The currently displayed
mode is selected as the switch is released. The Display Modes are: RATE (display rate), T01 (display
batch Total 1 as accumulating), T02 (display Totalizer 2), BATCH (display batch status), and T01-
(display batch Total 1 as depleting). The display mode can also be changed by pressing the [MODE]-
key (
UP ).The LLC will retain the last selected display mode.