AW Gear Meters LLC-E-BA - Manual (Page 18)

AW-Lake Company 8809 Industrial Drive, Franksville, WI 53126  web: www.aw-lake.com
 Tel: 262-884-9800  Fax: 262-884-9810  Email: [email protected]
REV. 1.3 LLC-E-BA Manual rev 3.3.10.DOC
18
programmable characters or letters. Example: Gal
Factory default is pul (for pulses)
The first (left-most) character is programmed/edited first. To choose a letter press the (UP) or (DN)-
key until the desired character or letter appears. Press the (SEL)-key to enter the 1st character. Repeat
the procedure for the 2nd character and enter with the (SEL)-key. Repeat for the 3rd character and
store the last entry with the (ENT)-key. The LLC will exit to the Display Mode.
This ends the variable programming procedure. The LLC-BA will display the currently selected
mode.
Batch Programming
The LLC-BA must be in the PROGRAM mode to program batch quantities. Nine different batches (1-
9) can be programmed. Program variables must be entered before the batch programming. Batch
quantities are based on the programmed KFT value, KFT engineering units and decimal point.
NOTE: The maximum value that can be entered for a batch is 429496 regardless of decimal
place. Values greater than 429496 will not be accepted. The more decimal places in the KFT, the
smaller the batch that can be programmed. To program larger batches it may be necessary to reduce
the number of decimal places in the KFT.
Example:
KFT = 214.38 and desired batch is 6000.00. Ignoring decimal location the value of 600000 is greater
than 429496 and will not be accepted. The solution is to reduce the decimal places of the programmed
KFT. With KFT changed to 214.4, batch will be 6000.0. Ignoring decimal location the value of 60000
is now less than 429496 and will be accepted.
To program a batch quantity, press the [BATCH]-key (
SEL
). The display will momentarily read SET
BATCH-->1 and then display BATCH1-> 0000000. Pressing the (SEL)-key again will increment the
batch number. With a batch selected, press and hold the (UP) or (DN)-key to increment or decrement
the batch quantity. To increase the increment or decrement rate, while holding the (UP) or (DN)-key,
press and hold the (SEL)-key for medium rate or the (ENT)-key for maximum rate. NOTE: Always
release (SEL) or (ENT)-key before releasing the (UP) or (DN)-key or the LLC may return to the
Display Mode leaving the batch quantity with an unpredictable value. When the desired batch
quantity is displayed, press the (ENT)-key to store the programmed value. This will also activate the
selected batch number and the LLC unit will return to the Display Mode. To program another Batch
quantity, repeat the above procedure. The [BATCH]-key (
SEL
) and (ENT)-key can be used for batch
selection /activation when in the PROGRAM mode. When programming is completed, the
RUN/PROG key switch must be returned to the horizontal RUN position to enter the RUN mode and
execute any selected/activated batch.
This ends the batch programming procedure. The LLC-BA will display the currently selected mode.
To initiate batch operation, the RUN/ PROGRAM key switch must be set to the horizontal RUN
position to enter the RUN mode.