AW Gear Meters LLC-E-BA - Manual (Page 9)

AW-Lake Company 8809 Industrial Drive, Franksville, WI 53126  web: www.aw-lake.com
 Tel: 262-884-9800  Fax: 262-884-9810  Email: [email protected]
REV. 1.3 LLC-E-BA Manual rev 3.3.10.DOC
9
Display Modes
RATE Display Mode - In the RATE display mode the unit will display the rate in engineering units
based on the KFR factor with the decimal point at the selected location and the programmed
engineering units at the end. The word RATE appears at the beginning of the display to indicate the
selected display mode.
A typical display would be: RATE 00000.34 GPM
TO1 Display Mode - In TOTALIZER 1 display mode the LLC displays the total of the currently
programmed BATCH in progress. Totalizer 1 is reset to zero on a START input when in RUN mode
and will count up to the programmed batch amount. This total is retained by the LLC with the power
removed. The display is based on the programmed KFT value, KFT engineering units, and decimal
point.
A typical display would be: TO1 000010.0 GAL
TO2 Display Mode - In TOTALIZER 2 display mode the LLC displays the current total
accumulating in Totalizer 2 (Grand Totalizer). Totalizer 2 accounts for all totalized flow and can only
be reset in the PROGRAM mode. This total is retained by the LLC with the power removed. The
display is based on the programmed KFT value, KFT engineering units and decimal point.
A typical display would be: TO2 000496.8 GAL
BATCH Status Display Mode - The BATCH status display mode indicates the state of the currently
selected batch. This display indicates which batch is selected and whether the batch is RUNNING,
PAUSED, or DONE. It does not indicate actual batch progress.
A typical display would be: BATCH 1 DONE
TO1- Display Mode (INVERSE TOTAL 1) - Displays batch quantity in currently selected batch
when START input is closed and counts downward to zero at batch completion in the inverse function
of Totalizer 1. Display is reset with Totalizer 1. This total is retained by the LLC with the power
removed. The display is based on the programmed KFT value, KFT engineering units, and decimal
point.
A typical display would be: TO1- 00000.00 GAL