Fire-Lite FCPS Series Field Charger/Power Supply - Manual (Page 17)

FCPS-24FS Series Instruction Manual — P/N 51883-L8:J1 8/30/13 17
Addressable Module Mounting Installation
2.3 Addressable Module Mounting
The FCPS-24FS has been designed to allow the mounting of an addressable control, relay or moni-
tor module on the main circuit board inside the power supply cabinet with the module status LED
visible through the closed door. This allows power to be fed from the FCPS-24FS Auxiliary Power
output directly to the module, if needed, without running the power wires outside the cabinet. As an
example, Figure 2.5 illustrates wiring from the Auxiliary power output terminals to a CMF-300
control module’s terminals 3 (-) and 4 (+).
NOTE: The optional module mounting kit (P/N 90286) is required to install an addressable
module on the power supply main circuit board. The kit includes four female/female and four
male/female standoffs as well as four mounting screws.
standoff
standoff standoff
standoff
2
4fsmo
dl
tp
H.wmf
*If the SLC device does not match the one in this figure,
refer to the SLC manual wiring conversion charts for leg-
acy and newer versions of the modules.
Module Installation
1. Remove FCPS-24FS main circuit board from
mounting plate by removing four corner screws.
2. Install four male/female standoffs through bottom of
board in holes indicated in illustration above.
3. Screw four female/female standoffs to male ends of
standoffs installed in Step 2 to secure in place.
4. Place addressable module over standoffs installed in
Step 3 and secure with supplied screws.
5. Reinstall main circuit board on mounting plate and
wire module as show in illustration above.
Figure 2.5 Mounting Module In FCPS-24FS Cabinet
female/female standoffs
female/female standoffs
addressable module
mounting screw
24f
smo
di
nst
l.w
mf