HT instruments HT5000 - Manual (Page 15)

HT-5000
EN - 14
4.2.3 Initial use of the transmitter TX5000
Follow the steps listed below in order to prepare the transmitter to search for lines in
conjunction with the receiver:
Step Action
1
Connect the transmitter to the line to be located using the most
suitable method, or place the transmitter on the site to be searched
see paragraph 4.2.2
2
Press to switch on the transmitter
3
Select the desired output signal using the and function keys
(see paragraph 4.1.3)
A green LED indicates that the respective setting is active
Select the desired mode of operation using the
button (see
paragraph 4.1.3)
4
Result:
In Direct mode, an LED next to the
symbol indicates how
good the connection is to the connected line:
• Green blinking: good (low-resistance) connection
• Alternating red and green: sufficient connection
• Red blinking: poor/no (high-resistance) connection
5
As described in paragraph 4.3.1 use the RX5000 to locate metallic
conductors
C
M P