HT instruments HT5000 - Manual (Page 7)

HT-5000
EN - 6
4.1.3 Description of transmitter TX5000
The TX5000 transmitter is distinguished by the following features:
• Inductive coupling of the signal using the integrated antenna or transmitter clamp
• Direct (galvanic) coupling of the signal using connected equipment (such as the
measurement cable and power socket adapter)
• Two-step adjustable transmission power (0.1W / 0.5W)
• Selectable signal output continuous or pulsed
Fig. 3: Front panel of transmitter TX5000
Item Description
1
Battery status indicator
When the battery status LED blinks in red, the batteries need
to be replaced
2
On/Off switch
By quickly pressing this button the TX5000 can be switched on
or off.
All appropriate LED’s blink when the transmitter is on,
depending on operating function
3
Signal type function key
This key is used to switch between continuous and pulsed
signal output
4
Jacks for connecting accessories
These jacks are used to create a direct galvanic connection
with the target line or to create a connection using a special
connection set (e.g. 100mm transmitter clamp or house
connection set)
5
Mode function key
This key is used to switch between inductive and direct signal
coupling (galvanically or via transmitter clamp)
6
Signal strength function key
This key is used to select one of two signal strength levels
(0.1W or 0.5W)