HT instruments HT5000 User Manual
Page 19
HT-5000
EN - 18
4.3.1.3 Changing of the system settings
Proceed as follows to change the settings:
Step Action
1
Briefly press the
button while continuing to hold down the
key
until an audible signal is heard. The following image is display:
2
Now one of the following depth measurement processes may be
selected by pressing the
key:
Select this symbol if you want to determine the depth of a
probe which has been pushed into a non-metallic pipe
Select this symbol if you want to determine the depth of a
line, the signal of an active transmitter is coupled onto
Now a unit of length used by the system may be selected by pressing
the
key:
Feet (ft)
Metre (m)
3
Press the
key to save the settings. The changes will remain in
effect even after the receiver is switched off and back on again
Proceed as follows to change the receiving frequency of operation modes with more than
one possible frequency:
Step Action
1
Briefly press the
key while continuing to hold down the
key until
an audible signal is heard. The selectable frequencies are now visible
in the display:
2
Use the
and
keys to switch between 50 and 60Hz. The active
setting is marked with a black background
3
Press the
key to save the settings. The changes will remain in
effect even after the receiver is switched off and back on again
2
3
1
3
2
3
1
1