In-Situ Con TROLL PRO Installation Manual (purchased before 10 May 2012) - Manual (Page 11)

Mounting the Controller 11
FIGURE 6. Side view dimensional drawings
3.2.2 Pole Mounting
1. Remove the four nuts and four screws from the mounting kit.
2. With the enclosure open, drop one nut into each drilled corner of the box
(Figure 7).
3. Use a screwdriver to push the nut down and set it in place (Figure 7).
FIGURE 7. Placing the nut in the enclosure
4. Orient the two brackets on the back of the enclosure so that the flanges on the
brackets will point toward the ground (Figure 8).
5. Attach the mounting brackets to the enclosure using two screws for each
bracket. Make sure that the screws properly thread into the nuts that you seated
in steps 2 and 3 (Figure 9).
6. Place two hose clamps over the mounting pole and tighten them until they
almost secure.
7. Place the flanges from the mounting bracket into each of the hose clamps
(Figure 9).
8. Completely tighten the hose clamps until the entire controller unit is secure on
the pole.
ASSEMBLY
7.6 cm
[3.0 in]
6.0 mm
[0.24 in]
8.4 cm
[3.3 in]
2.5 mm
[0.10 in]
2.5 mm
[0.10 in]
SECTION B-B
SECTION A-A
9.0 cm
[3.5 in]