KYORITSU 6300 Instruction Manual - Manual (Page 139)

12. 3
MODEL6300
Section 12 When defect or breakdown is suspected MODEL6300
12-2 Battery replacement
When the battery mark displayed on the LCD becomes “ ” , batteries are
almost exhausted.
DANGER
Ɣ Never open the Battery cover during a measurement.
WARNING
ŏ Remove Power cord, Voltage test leads and Clamp sensors from the instrument
and set the Function switch to OFF position before replacing the batteries.
CAUTION
Ɣ Do not mix new and old batteries.
Ɣ Install batteries in correct polarity as marked inside.
Ɣ Battery
Alkaline size AA battery
LR6 (1.5V) x 6pcs

Ɣ How to replace batteries
(1) Loosen two Battery cover-fixing screws, and remove the Battery cover.
(2) Install new batteries in correct polarity as marked inside.
(3) Then put the Battery cover and tighten up the screws.












Screws
Battery cover