KYORITSU 6300 Instruction Manual - Manual (Page 30)

MODEL6300
4. 4
MODEL6300 Section 4 Setting
Section
4
‣ ‧ ‣ ‧ • ⁈ • ⁈ ‥ • ‥ • • ⁈ • ⁈ • • • ⁈ ‣ ⁂ ‣ ⁂․ ⁉ ․ ⁉ ‣ ⁂‥ ⁉ ‥ ⁉ ‥ ⁂ ‥ ⁂‥ ⁉ ‥ ⁉ ‥ ⁂ … ⁉
‧ ″ ‧ ″ ‣ • ‣ • ″ ․ • ․ • ″ ‧ • ″ ‧ • ″ ‣ • ‣ • • ″ • ″ ․ • ․ • • ″ • ″ ‧ • • ‧ • • ″ ‣ • • • • • ″ • ″
‣ ‧ ‣ ‧• ⁈ • ⁈ ‥ • ‥ •• ⁈ • ⁈ • ••⁈ ‣ ⁂ ‣ ⁂․ ⁉ ․ ⁉ ‣⁂‥ ⁉ ‥ ⁉ ‥ ⁂ ‥ ⁂‥ ⁉ ‥ ⁉ ‥⁂ …⁉
‧″ ‧″ ‣• ‣• ″ ․• ․• ″ ‧•″ ‧•″ ‣• ‣• •″ •″ ․• ․• •″ •″ ‧•• ‧•• ″ ‣ •• •• •″ •″
4-3 Setting procedure of each setting item
NOTE
During the integration/demand measurement or in stand-by mode, the
settings can be viewed only for checking and cannot be changed.
(1) Setting item selection screen (hereinafter, called selection screen)
* Set the Function switch to SET UP range.
* Then selection screen is displayed, and
“ ” mark and item number appear.
* When turning on the instrument, setting
screen for; “Setting 01”: Wiring, is displayed.
(2) Setting Item number selection
* Press the Cursor key and select the desired
item number.
* Item number changes in following sequence.




(3) Changing the value/status of a Setting item
* Select the item number desired, press the
ENTER key to go into setting change mode.
* When the instrument is in setting change
mode, the previous set value (or default value)
will flicker.
* Press the Cursor key and select the
value/status desired.
* Press the
ENTER key to confirm the selection.
(4) Selection cancellation
* Following step (3) above, press the Esc key. This will cancel
value/status selected, restore the previous values and exit setting
change mode.
Item number
Setting01 Setting02 Setting24 Setting25 • • •
or
or