Asante Technologies INTRACORE 3724PWR - Manual (Page 56)

Switch(Interface 1)# poe
func Configure poe function on a port
power-pri Configure power priority on a port
detection Configure detection type on a port
high-power Configure Power Energy Mode on a port
Func is the setting that enables or disables the poe function on a particular port.
Power-pri
selects the priority policy to determine which ports still receive power is the maximum is
reached.
Static with priority: This mode considers the used power is port’s allocation and PSE provides the power to the port
with higher priority first.
Dynamic with priority: This mode considers the used power is port’s consumption and PSE provides the power to the
port with higher priority first.
Static without priority: This mode considers the used power is port’s allocation and PSE first provides the power to the
port which is first required.
Dynamic without priority: This mode considers the used power is port’s consumption and PSE first provides the
power to the port which is first required.
Detection
Indicates which PoE detection type has been chosen.
No Detection: PSE will provide power to PD without detection.
Legacy Capacitive Detection only: PSE would provide three points to test PD’s capacitance. After a PD is
successfully detected, power is delivered to the port, or not.
IEEE 802.3af 4-Point Detection only (Default): PSE would provide four points voltage to test PD’s resistance.
After a PD is successfully detected, power is delivered to the port, or not.
IEEE 802.3af 4-Point followed by Legacy: PSE would provide four points voltage to test PD’s capacitance. After a
PD is successfully detected, power is delivered to the port, or not.
IEEE 802.3af 2-Point only: PSE would provide two points voltage to test PD’s resistance. After a PD is
successfully detected, power is delivered to the port, or not.
IEEE 802.3af 2-Point followed by Legacy: PSE would provide two points voltage to test PD’s capacitance. After a
PD is successfully detected, power is delivered to the port, or not.
The first 2 options(No Detection, Legacy..) can be used for older legacy POE devices if the default detection
method does not detect the PD.
High-power enables or disables the 30 watt power limit mode. The default is 15 watts.
7.4 PoE Interface Settings Example
Here is an example of possible settings
56 Asante IC3724PWR User’s Manual