Pyromation Series 642 - Manual (Page 7)

Series 642 Installation
Pyromation, Inc. 7
3 Installation
3.1 Quick installation guide
If the sensor is fixed then the unit can be fitted directly to the sensor.
If the sensor is to be mounted at a right angle to the cable gland, swap the dummy plug and cable
gland.
The device can be mounted directly on the wall. A mounting bracket is available for pipe mounting
(see Fig. 4). The illuminated display can be mounted in four different positions (
→ å 2):
Fig. 2: Temperature field transmitter with sensor, 4 display positions, can be plugged-in in 90° steps
Fig. 3: Turning the display
1. Remove the cover clamp (Pos. 1).
2. Unscrew the housing cover together with the O-ring (Pos. 2).
3. Remove the display with retainer (Pos. 3) from the electronics module (Pos. 4). Adjust the
display with retainer in 90°stages to your desired position and rearrange it on the particular
slot in the electronics module.
4. Then screw on the housing cover together with the O-ring. Mount the cover clamp.