2 measuring, 1 measurement mode, 2 hold measured value – SHIMPO CEG-2000 User Manual
Page 12
-9-
6.2
Measuring
6.2.1
Measurement mode
• Items currently being shown in the bar display are indicated by the blinking (light
and dark) of “Item/decision lamps 1, 2, and 3.” For details on the colors of the
lamps, refer to 4. [5] “Item/decision lamps.”
• The up and down arrow keys can be used to toggle between bar display items.
6.2.2
Hold measured value
• In Measurement Mode, pressing the ENT key will hold the measured value (will
enter a holding state). However, if master matching was unsuccessful, the
measurements will not be held.
• For the item shown in the bar display, the Item/decision lamps will blink (light and
blank). For details on the colors of the lamps, refer to 4.[5] “Item/decision lamps.”
• The up and down arrow keys can be used to toggle between bar display items.
• Pressing RST (reset) releases the hold.
SET
MAS
RST
ENT
1
2
3
SET
MAS