SHIMPO CEG-2000 User Manual
Page 17
-14-
6.3.11
Selecting the calculation method (in Item 3 only)
1)
With “CALC” displayed, press the ENT key.
2)
The current calculation expression will be displayed.
3)
Use the up and down arrow keys to either select a calculation method, or select
“Use none.”
4)
After selecting the calculation method, press the ENT key.
5)
The eight-digit display will be shown.
6.3.12
Saving setting values (Saving the previous items 6.3.1-11)
If you quit while still inputting settings, “END” can be displayed by pressing both
reset and the left and right arrow keys.
1)
With “END” displayed, press the ENT key.
2)
“WRITE” will be displayed.
3)
Use the up and down arrow keys to either select either “WRITE” or
“CANCEL.”
4)
After making this selection, press the ENT key.
5)
Quit Set-up Mode and return to Measurement Mode.
! NOTE
In the calculation method display, “1” shows Item 1 and “2” shows
Item 2.
FINISH
Switches to the same state as in
B in 6.3.5 Item Selection
MAX
Switches to 6.3.7 Setting the
decision upper limit value
Selection items in
WRITE
Save the new settings.
Selection items in
CANCEL
Erase the new settings and revert
to the previous settings.