West Control Solutions N8100 - Manual (Page 3)

1
4
-DIN, 1
8
-DIN & 1
16
-DIN
TEMPERATURE CONTROLLERS
PRODUCT MANUAL
VOLUME 1
OPERATING INSTRUCTIONS
In normal operation, the operator must not remove the
Controller from its housing or have unrestricted access to
the rear terminals, as this would provide potential contact
with hazardous live parts.
Installation and configuration must be undertaken by
technically-competent servicing personnel. This is covered
in Volume 2 of this manual.
Contents - Volume 1
1 OPERATOR MODE 1-1
1.1 INTRODUCTION 1-1
1.2 DISPLAYS AVAILABLE 1-2
1.3 ADJUSTING THE SETPOINT/SETPOINT RAMP RATE 1-3
1.4 ALARM STATUS DISPLAY 1-3
1.5 OVER-RANGE/UNDER-RANGE DISPLAYS 1-4
1.6 SENSOR BREAK INDICATION 1-4
1.7 MANUAL CONTROL MODE 1-4
1.8 PRE-TUNE FACILITY 1-5
1.9 SELF-TUNE FACILITY 1-6
1.10 VIEWING THE HARDWARE DEFINITION CODE 1-7
O054-V1 (iii)
59125