PATLITE NHL - Manual (Page 11)

11
1
1.4 General Specifications
Item Specification
Model NHL-3FB1U-RYG NHL-3FB1N-RYG
Rated Voltage (Body) DC24V
AC Adaptor Rated Voltage AC 100V to 240V ―
AC Adaptor Operating Voltage Range AC 90V to 264V ―
Power Consumption
Body Red Amber Green Blue White Buzzer
2.0W 1.5W 1.5W 0.8W 0.8W 0.8W 2.0W
Operating Temperature Range 0 o C to 40 o C (No Condensation)
Storage Temperature Range -10 o C to 60 o C (No Condensation)
Relative Humidity from 20 to 80% RH (No Condensation)
Insulation Resistance More than 1MΩ at DC500V between the terminals and the chassis
Withstanding Voltage
AC1000V and less than 10mA applied for 1 minute between the terminals and
chassis without breaking insulation
EMI Noise Characteristics AC1000Vp~p Pulse Width: 1μsec
Vibration Resistance 19.6m/s 2
Sound Level
HIGH: 80dB or more / LOW: 70dB or less
(Distance from buzzer diaphram (Upright Position) of 1m and "A" balance)
Buzzer Sound Three-position adjustable switch for "HIGH", "LOW" and "OFF"
Signal Tower NHL：φ60 Type Clear Globe
"CLEAR" Switch Pushbutton Switch
"RESET" Switch Tact Switch
"BUZZER" Switch Slide Switch
Communication
Method
Ethernet
Physical Layer: 10BASE-T/100BASE-TX
（Auto-negotiation/ Full Duplex/ Half Duplex）
Data Link Layer: CSMA/CD
Network Link Layer: IP・ARP・ICMP
Transport Layer: TCP・UDP
Application Layer: HTTP・RSH・SMTP・SNMP・
POP・DNS・Socket・NTP・DHCP
Mounting
Location Indoors Only
Direction Desktop or wall-mount in the upright position
Mass
( AC Adaptor not included)
800g
Protection Rating IP2x
Accessories
AC Adaptor, Rubber Feet, Adhesive Seal,
Support Base
Rubber Feet, Adhesive Seal, Support
Base
1.5 AC Adaptor Specifications
When ordering an AC Adaptor separately, use the following specifications. Since the voltage output of AC
Adaptors drop when there is insufficient current (example: unregulated transformers, etc.), be sure to use an
output current rating above the recommended rating. Failure to comply may result in failure of this product.
Be sure to use AC Adaptors with built-in regulation systems to ensure a regulated output voltage (switching
power supplies, etc.)
[Recommended AC Adaptor Specifications]
DC Secondary Output
Voltage : 24V DC ±5%
Current : 0.75A to 1A max
Plug Length : 9.5mm
Plastic Housing : 11mm dia.
Plug Connector Outer Diameter : 5.5mm dia.
Plug Connector Inner Diameter : 2.1mm dia.
When there is no "Auto-negotiation" on the HUB side, sometimes communication is inoperable.
9.5
φ2.1 φ5.5 φ11
+ -
Please