PATLITE NHL - Manual (Page 16)

16
2
2.2 Signal Tower Installation
This product is to be intalled on a level surface. Also, use the included accessories (rubber feet, adhesive seal,
support base) when needed during installation.
Installation Example 1: Rubber Feet to prevent from sliding on a flat and slippery surface
Installation Example 2: Increasing surface area for a sturdy surface (before adding adhesive seals or rubber feet)
[Installation]
1. Support Base is attached to the part indicated by the
circle " ".
Support Base attachment area
2. Secure the Support Base with screws.
3. Use an M4 screw (or M4 bolt, etc.) to attach the
Support Base onto the installation surface and tighten
it with M4 nuts.
Adhesive seal or rubber feet attachment area
Attachment Area
Attachment Area
Clamp with
3 screws
Attachment Area
Attachment Area
[Installation]
Strip off the adhesive backing and stick the adhesive
seal or rubber feet in the shaded area, indicated on the
figure to the left.
Adhesive seal or rubber feet attachment area