PATLITE NHL - Manual (Page 39)

39
3
Event
Name
PING Event Contents Ping monitor abnormalities and the IP address object
Ping abnormality response and the IP address object
Event
Details
It records when the Ping monitor status changes.
"Ping Monitoring Error": When an abnormality event in the Ping monitor occurs, it records it with the target
IP address.
"Ping Recovery": When an abnormality in the Ping monitor is restored, it records it with the target IP
address.
Event
Name
APL Event Contents Application Monitoring Error
Applicaton Recovery
Event
Details
It records when an abnormality in the application monitor is detected.
"Application Monitoring Error": It records when the abnormalities in an application monitor occurs.
"Applicaton Recovery": It records when the abnormality in the application monitor is restored.
Event
Name
TRAP Event Contents Trap reception IP address and the designated sender
Event
Details
When a registered Trap is received, it is recorded with the IP address of the designated sender.
Event
Name
CLEAR Event Contents
"RSH" IP address and designated sender
Web Setup Tool "Clear"
"PNS" Command
"CLEAR Switch"
”SNMP” Command
Event
Details
The Signal Tower is returned to its normal operating status during operation.
"CLEAR" Switch": It records when the clear switch to this product is pushed.
"SNMP": It records when a "CLEAR" has been executed by the SNMP Command (controlLightSnmpClear).
"RSH": It records when a "CLEAR" has been executed by the RSH Command, and displays the
designated sender IP address.
"PNS Command": It records when a "CLEAR" has been executed by the PNS Command.
Event
Name
RSH Event Contents
IP address, command argument, and the "alert" designated sender.※
"Status"
"Test"
Event
Details
It records when the RSH Command is executed. (The "clear" execution is not included)
"ALERT": When the alert command is executed, it records the argument and designated sender IP
address.
※ An IP address is not written in cases where the designated sender address is inactivated.
"Status": The status command is recorded at the time of execution.
"Test": The test command records at the time of execution.
Event
Name
SNMP Event Contents ”CONTROL”
Event
Details
When this product is operated by the SNMP Set Commands, the Signal-Tower color and buzzer conditions
are recorded.
The applicable command is "controlLightControlState".
3.15 Configuration Data Save/Load Setup
The setting menu for this product is read and can be saved as configuration data on the PC.
Also, configuration data which was read can be selected to be written in.
The config setup is done from the Web Setup Tool.
Refer to "4.19 Configuration Data Save/Load Setup Screen" for the setting method.
3.16 Firmware Update Function
The firmware for this product can be updated.
The firmware is updated via the Web Setup Tool.
Refer to "4.20 Firmware Update Screen" for the setting method.