Sterlco M2B+ Controller - Manual (Page 38)

38 of 68
5-9 Using the Elapsed Time Meter
The controller is equipped with an elapsed time meter that keeps track of the time that the
pump motor has run in hours. The meter is enabled or reset in the Secure menu and viewed
in the Primary menu.
Use the following procedure to enable the elapsed time meter:
1. Press the Index button three times to access the Secure menu.
2. Press the Enter button.
3. Press the Index button until the display reads “ElapsedTimeMode.”
4. Use the Up and Down buttons to change the value to “ON.”
5. Press the Enter button to accept the value.
6. Press the Alarm Silence button to return to Running mode.
Use the following procedure to view the elapsed time meter:
1. Press the Index button one time to access the Primary menu.
2. Press the Enter button.
3. Press the Index button until the display reads “ElapsedTime.”
4. Press the Alarm Silence button to return to Running mode.
Use the following procedure to reset the elapsed time meter:
1. Press the Index button three times to access the Secure menu.
2. Press the Enter button.
3. Press the Index button until the display reads “ElapsedTimeMode.”
4. Use the Up and Down buttons to change the value to “RST.”
5. Press the Enter button to accept the value.
6. Press the Alarm Silence button to return to Running mode. At this point the meter has
been reset to zero hours.