Sterlco SMS Series Single Shaft Shredder User Manual
Page 32
Advertising
GRN4-605
Chapter 3: Installation
32 of 93
ü
Allow machine to run for approximately 10 minutes without shredding material.
ü
Connect material discharge device and in-feed device; check rotational direction
drives.
ü
Feed grinding material uniformly. Too much grinding material can lead to overload
of the machine.
ü
Check the temperature of the shredded material if necessary.
ü
Monitor the ammeter. This displays the present current consumption and gives
information on the load of the machine.
Advertising