Sterlco SMS Series Single Shaft Shredder - Manual (Page 50)

GRN4-605 Chapter 5: Maintenance 50 of 93
7. Loose the screw using a high quality Allen key (10 mm). If necessary knock the
Allen key lightly with a hammer to loose it.
8. Take out the cutter mounting screw, the washer and the cutter.
9. Clean the hexagon head socket of the cutter holder mounting screws (4).
10. Loose the screw using a high quality Allen key (6 mm). Knock the Allen key
lightly with a hammer to loose it if necessary.
11. Take out the cutter holder mounting screws.
12. Remove the cutter holder with the delivered Extractor.
NOTE: See previous drawing.
Danger of cutting caused by sharp cutters at all times—even when rotor is at standstill.
Serious Injury especially to the hands and fingers can occur. Wear protective gloves!
Dismounting the Bed Cutters
1. Switch OFF the shredder at the main switch.
2. Safeguard main switch using a padlock.
3. Open the upper hopper door.
4. Safeguard the hopper door.
NOTE: Although it is possible to reach the cutters by climbing into the feeding
chamber, it is recommended to access the cutters through the front side door.