TOHO ELECTRONICS TTM-509 - Manual (Page 39)

TOHO TOHO ELECTRONICS INC.
DWG. No.
45-4199-E
PAGE
39/66
4.4 Setting initial value and setting range
4.4.1 Operation mode
Character
PV screen
Auxiliary screen Designation Description Initial value
1 PV value
(CH/MV/BANK
display) Control setting Setting range:  to (CH1)
 to (CH2)
Setting unit: °C (thermocouple, resistance bulb)
digit (current and voltage inputs)

CH2 only, % (potentiometer)
2 to
10
Priority screens
1 to 9 They display a screen preset in priority screen 0 setting.
Use the MODE key for switchover.
11 to
19
Priority screens
11 to 19 They display a screen preset in priority screen 1 setting.
Set the FUNC 1 key to "Switch over priority screens" to
perform switchover.
20 to
28
Priority screens
21 to 29 They display a screen preset in priority screen 2 setting.
Set the FUNC 2 key to "Switch over priority screens" to
perform switchover.
29 to
37
Priority screens
31 to 39 They display a screen preset in priority screen 3 setting.
Set the FUNC 3 key to "Switch over priority screens" to
perform switchover.
4.4.2 Bank setting mode
The code "bk" represents bank numbers ( to ).
While in the operation mode, pres the MODE key for 3 seconds. When in the setting mode, press
the key. Hold it down for a total of 6 seconds or more until the system enters the bank setting
mode.
To go back to the operation mode, hold the MODE key for 6 seconds or more while in the "Set
bank bk SV" screen.
Character
PV screen
Auxiliary screen Designation Description Initial value
1  bk
(□/
□
)
"Set bank bk SV"
screen Setting range:  to (CH1)
 to (CH2)
Setting unit: °C (thermocouple, resistance bulb)
digit (current and voltage inputs)

CH2 only, % (potentiometer)
2 □
(□/
□
)
Display bank bk This displays bank numbers on the SV screen.
 bk (0 to 7)
The subsequent operation flow is the same as
□.