TOHO ELECTRONICS TTM-509 User Manual
Page 62
TOHO
TOHO ELECTRONICS INC.
DWG. No.
45-4199-E
PAGE
62/66
4.4.16 Key setting mode
Character
PV screen
Auxiliary screen
Designation
Description
Initial value
1
□
□□□□
Select key setting
Setting concerning key setting
2
3
4
□
to
□
Set the FUNC 1 to
3 key
: No function
: Starts and stops AT
: RUN/READY
: Starts and resets the timer
: Releases event holding
: Secret (See 4.6 "Secret function.")
: Forcible control output ON
: Power OFF
: Starts and stops logging
: Switchover key for priority screens
Setting the system to FUNC 1 will switch the system
over with the priority screen for .
5
□
Set an A/M key
: Enable
: Disable
6
□
Set the ENT key
: The setting can be finalized without pressing the
ENT key.
: The setting is finalized by pressing the ENT key.
7
Set the operation
mode display
This sets the first screen to be displayed on the operation
mode screen after the system is turned on.
: Displays the PV, SV, and auxiliary screen.
: Displays the priority screen.
(This displays the priority screen having the smallest
number when priority screens are set.)
8
Set an auxiliary
screen display
This sets the first auxiliary screen to be displayed after
the system is turned on or when it goes back to the
operation mode screen.
PV display
SV display
CH display
: CH
CH1 PV
CH1 SV
: MV 1 of CH 1 (main output)
CH1 PV
CH1 SV
CH1 MV1
: MV 2 of CH 1 (auxiliary output)
CH1 PV
CH1 SV
CH1 MV2
: MV 1 of CH 2 (main output) *1
CH2 PV
CH2 SV
CH2 MV1
: MV 2 of CH 2 (auxiliary output)*1 CH2 PV
CH2 SV
CH2 MV2
: Bank display
CH1 PV
CH1 SV
*1 Only when CH 2 is available
9
□
Initial setting
Holding down the ENT key for at least 2 seconds will
switch the setting value back its initial state (the
factory-configured parameters).
During initialization, the SV screen displays .
10
□
Set a key lock
: OFF
: Locks all
: Locks the operation mode
: Locks everything other than the operation mode.