Transmille 8000 Series - Manual (Page 62)

8000 SERIES OPERATION MANUAL
TRANSMILLE LTD. Page 61
SCPI
Command words are separated by a colon. A space is required between the command words and
the parameters. Command words are not case sensitive.
Command Format Parameters
Transmit Reading READ?
*TRG
Select AC Voltage Range RANGE:AC:VOLTAGE<space> <value>
RANGE:AC:VOLT<space> <value> value = 0.01 to 1000
Select DC Voltage Range RANGE:DC:VOLTAGE<space> <value>
RANGE:DC:VOLT <space><value> value = 0.1 to 1000
Select AC Current Range RANGE:AC:CURRENT <space><value>
RANGE:AC:CURR<space> <value> value = 10
-4
to 30
Select DC Current Range RANGE:DC:CURRENT <space><value>
RANGE:DC:CURR<space> <value> value = 10
-8
to 30
Select 4-Wire Resistance RANGE:FRES<space> <value>
RANGE:FRESISTANCE<space>
<value> value=1 to 10
7
Select 4-Wire Resistance
Low measurement current RANGE:FRES:LOWI<space> <value>
RANGE:FRESISTANCE:LOWI<space>
<value> value=100 to 10,000
Select 2-Wire Resistance RANGE:RES <space><value>
RANGE:RESISTANCE <space><value> value=1 to 10
12
Select 2-Wire Resistance
Low measurement current RANGE:RES:LOWI<space> <value>
RANGE:RESISTANCE:LOWI<space>
<value> value=100 to 10,000
value may be modified by
SI Prefixes: n, u, m, k, M,
G, T. Exponent notation
should be used for
numbers less than 10
-7
(1.0E-7)
Identification String *IDN?
Example Commands (where <CR> denotes Carriage Return (ASCII 13) :
Required
Output
Range
Command
Output
Value
Command
Separator
Filter
Command
Terminator
(Carriage
Return)
1V DC @ 2s Filter RANGE:DC:VOLT 1 / F4 <CR>
10V AC @ 4s Filter RANGE:AC:VOLT 10 / F5 <CR>
100mA DC @
500ms Filter
RANGE:DC:CUR
R
0.1 / F2 <CR>