Brother MFC-820CW - Manual (Page 29)

Configuring your machine for a wireless network
3 - 8
3
Using the SecureEasySetup TM software to configure your machine for a
wireless network
The SecureEasySetup TM software allows you to configure the wireless network easier than configuring it
manually. By pushing a button on the wireless router or access point, you can complete setup and secure the
wireless network. Your router or access point must also support SecureEasySetup
TM . See the user’s guide
for your wireless LAN router or access point for instructions to configure your machine for a wireless network.
Note
Routers or access points that support SecureEasySetup TM have the SecureEasySetup TM symbol as shown
below.
(For MFC-640CW)
1
Place your computer closer to the Brother machine (Less than 50 cm/20 in.).
2
Push the SecureEasySetup TM button on your wireless router or access point. See the user’s guide for
your wireless router or access point for instructions.
3
Press Menu/Set, 5, 3, 2 on the control panel of the Brother machine.
4
The wireless network connection status using the SecureEasySetup TM software will be displayed;
Connecting WLAN, Connected or Connection Error.
Connecting WLAN is displayed when the print server is trying to make connections to your router or
access point. Wait till either
Connected or Connection Error is displayed.
Connected is displayed when the print server is successfully connected to your router or access point.
You can now use your machine in a wireless network.
Connection Error is displayed when the print server has not successfully connected to your router
or access point. Try starting from Step 1 again. If the same message is displayed again, reset the print
server back to the default factory settings and try again.
5
Press Stop/Exit.