Atlantis Land IP Security Cam A02-WIPCAM-11B - Manual (Page 11)

IP Security Cam
4
4.2 Rear Panel
Network Cable Connector
The IP Security Cam’s rear panel features an RJ-45 connector for connections to 10Base-T Ethernet cabling or
100Base-TX Fast Ethernet cabling (which should be Category 5 twisted-pair cable). The port supports the NWay
protocol, allowing the IP Security Cam to automatically detect or negotiate the transmission speed of the network.
DC Power Connector
The DC power input connector is located on the IP Security Cam’s rear panel, and is labeled DC 5V with a single
jack socket to supply power to the IP Security Cam. Power will be generated when the power supply is connected
to a wall outlet.
Reset Button
Reset will be initiated when the reset button is pressed once, and Power LED begins to flash.
Factory Reset will be initiated when the reset button is pressed continuously for three seconds or when Power LED
begins to light up. Release the reset button and the Power LED will begin to flash, indicating the IP Security Cam
is changing to factory reset. When factory reset is completed, the IP Security Cam will be set to default on channel
11 and ESS-ID is set as “NULL String” (This default setting will let the IP Security Cam connect to ANY access
point on the infrastructure network). The IP address will also return to the default setting as 192.168.0.20.
Antenna Connector
There is the SMA type antenna connector located on the rear panel of the IP Security Cam, providing connection
for one high sensitivity antenna included in the package.
Network Cable
Connector
DC Power
Connector
Reset Button
Antenna
Connector
10/100 Ethernet
DC 5V
Reset
ANT