Atlantis Land IP Security Cam A02-WIPCAM-11B - Manual (Page 26)

IP Security Cam
19
8.3.4 DateTime
The DateTime menu contains commands for setting the IP Security Cam's time and date requirements to provide
correct information to users who might be thousands of miles away in the remote site. There are two options to
select from the DateTime menu bar either Synchronized with Time Server or Set Manually.
Click “DateTime” in the system administration menu bar and the DateTime screen will appear as illustrated
below:
DateTime:
Select “Synchronized with Time Server” and the time will be based on GMT setting. The time will be
synchronized every 10 minutes. This is also the default setting for the IP Security Cam.
IP Address:
Enter the IP Address of the Time Server in this field.
Protocol:
Two options of NTP or Time are available for your selection to link with the Time Server. The default setting is
NTP.
TimeZone:
The system administrator must select the time zone for the region.
To set the Date Time manually, select “Set Manually” and the system administrator must enter the Date and Time
in the respective field manually.
Please refer to the appendix for the time zone selection table.
When you select Set Manually, every time when the IP Security Cam is powered off and
on, you must re-enter the details once again due to time lost.
Save/Cancel:
After making sure all settings in the DateTime are correct, click the “Save” button to store the settings for the IP
Security Cam. You can alternatively click the “Cancel” button to restore all settings to the values last saved to or
retrieved from the IP Security Cam.
Click “Home” to
return to Welcome
Screen