Canon PowerShot SX510 HS - Manual (Page 29)

29
1
2
3
4
5
6
7
8
9
10
Cover
Before Use
Common Camera
Operations
Advanced Guide
Camera Basics
Auto Mode
Other Shooting
Modes
P Mode
Playback Mode
Wi-Fi Functions
Setting Menu
Accessories
Appendix
Index
Basic Guide
Tv, Av, and M
Mode
Still Images
• A blinking [ ] icon warns that images are more likely to be blurred
by camera shake. In this case, mount the camera on a tripod or take
other measures to keep it still.
• If your shots are dark despite the flash firing, move closer to the
subject. For details on the flash range, see “Flash Range” ( = 161 ).
• The subject may be too close if the camera only beeps once when
you press the shutter button halfway. For details on the focusing
range (shooting range), see “Shooting Range” ( = 161 ).
• To reduce red-eye and to assist in focusing, the lamp may be
activated when shooting in low-light conditions.
• A blinking [ h] icon displayed when you attempt to shoot indicates
that shooting is not possible until the flash has finished recharging.
Shooting can resume as soon as the flash is ready, so either press
the shutter button all the way down and wait, or release it and press
it again.
• Although you can shoot again before the shooting screen is
displayed, your previous shot may determine the focus, brightness,
and colors used.
• You can change how long images are displayed after shots ( = 40 ).
Movies
• Before shooting a movie, lower the flash
with your finger. Be careful not to touch
the microphone when shooting a movie.
Leaving the flash raised, or blocking
the microphone may prevent audio
from being recorded or may cause the
recording to sound muffled.
• Avoid touching camera controls other than the movie button when
shooting movies, because sounds made by the camera will be
recorded.
• Once movie recording begins, a smaller image display area is
shown, with the subject enlarged. This change is due to rotational
image stabilization. To shoot subjects at the same size shown
before shooting, adjust the image stabilization setting ( = 67 ).
• Audio is recorded in stereo.
• Distorted audio caused by recording when the wind is strong can be reduced.
However, the recording may sound unnatural when this option is used when
there is no wind. When the wind is not strong, press the < n> button,
choose [Wind Filter] on the [ 4] tab, and then choose [Off] ( = 23 ).
Microphone