Ipv6 – Canon VB-C60 User Manual
Page 25
1-9
Setting the Administrator Password, LAN, IPv6, DNS, etc. (Network)
1
1
Det
ai
led Set
tings
IPv6
(1) [IPv6]
Select [Disable] or [Enable] regarding the use of IPv6.
(2) [IPv6 Address]
If [Enable] is selected for IPv6, an automatically acquired address will be shown.
Note
z For [IP Address], [Subnet Mask] and [Default Gateway Address], contact your network
administrator.
z If any of the [IP Address], [Subnet Mask] and [Default Gateway Address] settings is wrong,
network access may be disabled. In this case, use VB Initial Setting Tool ("Perform Initial
Setting of the Camera" in Start Guide) to set the address again.
z If the [IP Address], [Subnet Mask], [Default Gateway Address], [LAN Interface] or
[Maximum Packet Size] setting is changed, the camera may become no longer accessible
from the active browser. Check beforehand the precautions explained in "Notes" in "Setting
the Items Requiring Rebooting (Reboot Item)" ( P. 1-49). Also check the precautions in the
same section before changing each setting in "[IPv6]" ( P. 1-9) and "DNS" ( P. 1-10).
z If [Auto (DHCP)] is selected as the address setting mode, the IP address may not be
assigned correctly in certain environments, such as when a router is present between the
DHCP server and this camera. In this case, assign a fixed IP address by selecting
[Manual].
z If you are using IPv6, set 1280 or greater value under [Maximum Packet Size].
Tip
z If you are using optical fiber or ADSL, you may be able to improve the sending efficiency by
slightly reducing the maximum packet size.
z You can use the VB Initial Setting Tool to check the IP address assigned by [Auto (DHCP)].
Tip
In an environment where IPv6 cannot be used, the [IPv6 Address] field remains blank even
when [Used] is selected for IPv6.