Water Inc HP-RO-1000 - Manual (Page 5)

4. Mounting the System
CAUTION
support the weight of the cartridges and help
prevent strain on the water lines.
A. Select location under sink or in basement where unit
is to be mounted. The head assembly is mounted in a
vertical position.
B. When mounting the HP-RO-1000 two screws are supplied
cabinet 14-1/2". This will provide clearance to change
the cartridges. The two screws will be 14" apart and
level. Screw the two screws into the wall. Leave a
gap between the screw head and the wall of 1/8". The
over the screw heads and slide down to lock.
B
14 Inches
Between Holes
12 Inches
From Mounting
Hole to Bottom
of Cartridge
2-1/2 Inches Clearance Below Cartridges
Figure 7
INSTALLATION continued
HP-RO-1000 Undersink Reverse Osmosis System • 5