HP Integrity NonStop H-Series - Manual (Page 24)

Installing and Configuring the Tape Drive
5158ACL Tape Drive Installation and User’s Guide — 524955-002
2 -4
Setting the SCSI ID
end of the fourth line means you can scroll to additional configuration
options.
4. To select a configuration option, press the up or down button on the control
panel to move the cursor to the option you want to change. In this case,
select Set SCSI. Press Enter to display the choices for that option. The
menu in
Figure 2-6 appears.
5. The Library SCSI ID is set to 3. If the DLT1 bus ID needs to be set to 5,
check that the cursor is next to line 1, and press the down button repeatedly
until the display scrolls, as shown in Figure 2-7 .
Figure 2-5. Configure Menu
Figure 2-6. Set SCSI Menu
Note. In Figure 2-6. Note that the cursor is next to line 1, and that line 2 is indented, indicating
a two-tiered menu. The scroll buttons work on two levels in this type of menu, which is typical
of many menus under Configure. First-level navigation: When you press the down button, the
cursor moves to line 3. Pressing the down button again, you will scroll down to DLT Bus ID. If
you press the up button, the cursor moves back to line 1.
If you press Enter while the cursor is next to line 1 (or line 3), the scroll buttons operate on the
second level. As a result, the cursor moves next to line 2 (or line 4), and a down arrow appears
at the end of line 4, indicating a list of options that you can view by scrolling.
Figure 2-7. Set SCSI Menu Scrolled