HP Hitachi Dynamic Link Manager Software - Manual (Page 106)

90 Chapter 3 Creating an HDLM Environment
Trace Level : 0
Trace File Size(KB) : 1000
Number Of Trace Files : 4
Path Health Checking : on(30)
Auto Failback : off
Remove LU : off
Intermittent Error Monitor : off
HDLM Manager Ver WakeupTime
Alive xx-xx yyyy/mm/dd hh:mm:ss
HDLM Alert Driver Ver WakeupTime ElogMem Size
Alive xx-xx yyyy/mm/dd hh:mm:ss 128
HDLM Driver Ver WakeupTime
Alive xx-xx yyyy/mm/dd hh:mm:ss
License Type Expiration
Permanent -
KAPL01001-I The HDLM command completed normally. Operation name = view, completion
time =
yyyy/mm/dd hh:mm:ss
21. Use the results of the view operation to check the version of the installed HDLM. When
05-91 is displayed in HDLM Version, the correct version of HDLM has been installed.
22. Use the results of the view operation to check that the programs are running properly. If
HDLM Manager, HDLM Alert Driver, and HDLM Driver are all Alive, all programs
are running correctly.
23. Check the path information as described in 3.7, and make sure that you have
successfully installed HDLM in a single-path configuration.
24. Connect cables to all HBAs (multi-path configuration).
Figure 3.4 shows a single path configuration and a multi-path configuration.
Figure 3.4 Single Path Configuration and Multi-Path Configuration
25. Check the path information as described in Figure 3.4 to make sure that you have
successfully built a multi-path configuration.